How to Pin or Unpin Earrings

  • It is not uncommon to find people trying to unpin a chain or doing other tasks using their fingernails. This is not as common a task as you might think. The majority of women and men alike have done this at some point in time. It’s something that many people do naturally. For others it can be a learned skill. If you’re one of these people, you might learn how to unpin a pendant or perform other foundation slaps.

How to Pin or Unpin Earrings

To unplug a device, you must first locate a loop and/or clasp that you can use to remove the chain. A charm bracelet would be a good example. You can remove the chains from earrings or other jewelry by finding a way to loosen it without actually removing the earring. In most cases, the earring will have a clasp or loop already attached. If it doesn’t, you will need one made or a clasp that can unplug and be used.

How to Pin or Unpin Earrings

Once you have the clasp selected, then you can start unplugging the chain from the clasp. Depending on the type and size of your chain, you will only be able to remove approximately half of the chain. Simply slide the chain off and lay flat on the ground. Ensure that the chain is not buried in the dirt or grass while being removed.

How to Pin or Unpin Earrings

If the chain still looks too tight, then you can try to twist it a little bit. This is another way to unplug the chain. The thread on the chain should not be cut. The best rule of thumb is to twist your chain until it doesn’t look tight anymore, but don’t pull it too loose. If it is, you can move on to the unplugging.

The last thing that we’re going to talk about is using pliers to remove the remaining chain. This is the easiest and most efficient way to do this. Simply use a pair of scissors to bend the chain so that it is easier for you to remove it. Make sure that you hold the chain securely while you do this or you could tear some of the earring material.

Now that the chain has been removed you will need the clasp to be re-inserted. There are usually two clasps on each earring. You will need to remove the clasps and re-addle your chain to ensure it is secure. The clasp will have a small gap where it was attached previously, so be careful when putting it back in. If you are unsure how to fasten it, ask an assistant in the store.

Once your chain is in place, you can secure the clasps with a nut filler. This will prevent you from tightening or loosening the chain while the earring is being worn. Make sure that the clasp you attach to the chain is the right size and thread.

Once all your earrings have been re-ordered it is time for you to take out your earring organizer. This works by removing the earring hooks as well as the chain from your ears. Then, you will slide the earring parts to the side. You will then insert each piece into its own hole in the organizer. This process is done a few times in order to ensure that your earrings are well-installed and securely on your ears.